thank you!
is it difficult to put one 2G/3G toggle also?
My question is why would you want to manually turn off 3g? Doesnt it auto toggle anyways?
Sent from my DROID3 using Tapatalk
thank you!
is it difficult to put one 2G/3G toggle also?
And sometimes there are areas where 3g coverage is not that good..and I get some interruptions when talking on the phone..so I keep it on 2g when I know I am in that area.
DYP, yes. when you turn off 3G it moves to 2G automatically. this is how i do it right now on ICS CM9. there you can chose between 2G/3G/2G and 3G
GreenSnow , I explained earlier on the previous page. i travel a lot...
it seems that voice calls drain my battery so much faster than it did when it was stock. is this normal? overall, I'm not getting any battery life than I did with stock. any ideas other than the obvious brightness/running apps/etc... ?
I've noticed this also. May be a 905 issue. Going to update system from 905 to 906 for next release. Perhaps this may help.
Sent from my DROID3 using DroidForums
Honestly I would hold off on updating to the leaked 906. 2 reasons why. The baseband and kernel seem to cause issues with the cm9 and ICS roms and most importantly you cannot do a full fastboot. You can only fastboot back system partitions, not the kernel. The 906 base I will use with be what you need.
Sent from my DROID3 using DroidForums
What issues does the 906 cause? I'm on the leaked 906 and using CM9 ICS as my daily an don't have any issues at all. I've been seeing a lot of people on here having issues but they are still on stock 890. I use to have the same issues till I updated to the 906
Sent from my Droid 3 using DroidForums
Mostly signal and battery issues. I've seen it with quite a few people. Hashs development on the d3 he tests on his own device I believe he is still on 5.6.890. So a few quarks have arrived because of the differences in the kernel modules. If you remember he had to release a patch for his cm7 development for 5.7.894 users for this reason. Just something to keep in mind.
Sent from my DROID3 using DroidForums
But how can you boot or return to stock when on 905? That's the same as 906 from this point of view? A few times, I tried to uninstall cwm and to install hashcode's safestrap and I remained in moto logo when in 905..and it helped me to install 905 again in stock recovery...to get out of logo loop. But now, if a do a complete wipe in stock recovery get..maverick stock 3.5..not stock 905... weird.
And if I install 906..it works, but just that after that, if a do a complete wipe..it returns to 905. Very..very strange behaviour )
Sent from my XT862 using DroidForums