coltzfan
Member
Ok here is my situation. Yesterday I SBF and installed DXGBRooted and installed the DX/D2overclock and set it at ULV 1.2ghz and it was running extremely fast....averaging 1900 on Quadrant and Smartbench 2011 was good as well. So I set at boot and when I rebooted it froze and I could not get back to DX bootstrap as I was unaware of the debugging was causing the issue. and I had to SBF and start all over again.
Today, I installed the Deodex over the DXGBRooted and have it up and running. I tried Quickclock as I was more familiar with it and it was calibrating for over 45 minutes for the VSEL at 300mhz and I finally cancelled it at -276 and I had lag big time. uninstalled and rebooted and went back to the stock launcher by deleting Golauncher and am playing with DXoverclock now. So here are my results.....
Medium volt 1.2 ghz not set at boot yet....
My Smartbench score was 941, 947, 944
My Quardrant was 1496, 1507, 1570, 2032, 2137, 2049, 2082, 2106, 1798
I am still not sure I should set at boot for the above reason, although now that I am running D2 bootstrap, i can get back to recovery, but these Quad scores to me seem to be rather erratic. The last time I did any over clocking and it was on the D1 installing ULV kernels from Chevy. That was easy.
Should I set at boot? or just overclock each time I boot up? I am looking for better battery life and snappier response. What is the opinions of everyone about overclocking with GB...is it worth it? does my quad scores seem correct? or should I just say screw it and stick with the stock speeds and voltage?
Thanks
Today, I installed the Deodex over the DXGBRooted and have it up and running. I tried Quickclock as I was more familiar with it and it was calibrating for over 45 minutes for the VSEL at 300mhz and I finally cancelled it at -276 and I had lag big time. uninstalled and rebooted and went back to the stock launcher by deleting Golauncher and am playing with DXoverclock now. So here are my results.....
Medium volt 1.2 ghz not set at boot yet....
My Smartbench score was 941, 947, 944
My Quardrant was 1496, 1507, 1570, 2032, 2137, 2049, 2082, 2106, 1798
I am still not sure I should set at boot for the above reason, although now that I am running D2 bootstrap, i can get back to recovery, but these Quad scores to me seem to be rather erratic. The last time I did any over clocking and it was on the D1 installing ULV kernels from Chevy. That was easy.
Should I set at boot? or just overclock each time I boot up? I am looking for better battery life and snappier response. What is the opinions of everyone about overclocking with GB...is it worth it? does my quad scores seem correct? or should I just say screw it and stick with the stock speeds and voltage?
Thanks