Body Glove modification?

admoore9

New Member
Joined
Nov 9, 2009
Messages
3
Reaction score
0
So, I was using my Droid today and noticed a couple things about the right side of the top part of the Body Glove (the part that doesn't clip on.

1. it scratches the the side that it covers.
2. it makes it hard to use the physical keyboard.
3. it isn't attached by anything and is flimsy.

Any reason why it would be a bad idea to just cut it off on the red dotted lines (picture doesn't have the glove on, but imagine that it is there)? I can't think of any cons. -Andrew

28lcfa.jpg
 
Last edited:

Repose

New Member
Joined
Nov 12, 2009
Messages
5
Reaction score
0
But why? I have the same case, and that isn't the part that causes it to be hard to use the physical keyboard. It's the opposite side of the top piece.

Might as well keep it on as if it were dropped at the angle and it hit the ground, it would mess it up rather horribly.
 
OP
A

admoore9

New Member
Joined
Nov 9, 2009
Messages
3
Reaction score
0
But why? I have the same case, and that isn't the part that causes it to be hard to use the physical keyboard. It's the opposite side of the top piece.

This part gets in the way of your fingers and makes it hard to type.
 

kckrawford

New Member
Joined
Nov 4, 2009
Messages
2
Reaction score
0
Location
Timpson, TX
I can't see where it would be bad to cut it. I might just have to try it and see. I'm sure it would make it easier to type on
 
Top