So I got a TB this past week, and love the thing. Coming from an OG Droid, it's a huge step up (even when I had that sucker overclocked at 1250 Mhz.).
Anyhoo, the bottom right, and right hand part of the digitizer is about 1 mil higher than the case, whereas the rest of it sits perfectly flush. Also, if you push down on it, it will push down to make it flush, then slowly rebound.
This makes me think the digitizer glue/sticky tape isn't holding like it should.
Does anybody have a fix for this?
I'm assuming I will probably need to take the digitizer off, replace the glue/sticky tape, and then go from there. In which case, can the digitizer be peeled up without disconnecting it, therefore not needing to take the phone completely apart?