Issue getting Link2sd script to mount ext4 partition on boot with SD10rc1

[metalspring]

You know I was jsut tring to figure out why I am only seeing a max allowable setting in SETCPU of 1000mhz instead of the 1.2 1.25 ( if you have any info on this I am all ears) But I was reading the deprimed break if you can thread. Here is a line in the first info post by Prime



I never ran this, did you? Is this why I was having an issue ? Not running this do you think its going to be an issue now? Seems everything is OK but do not want to click on something in a certain order and have a big issue.

I never used that script and its always worked fine for me
also to set different speeds just type this in terminal

su
1200

then go to /etc/init.d/20overclock to edit the last speed setting to 1250 (forgot how many zeros there are but just delete one and add the #5 in) and make sure to change the max vsel (near the end above the top speed, it should be set at 80) if you want 1.25 GHz then you'll probably want to set it at 86
If you want to experiment with slightly lower vsels (can improve battery life and heat) then download the milestone overclock app in the deprimed op to test different ones out

[bigeasy911]

Thanks

It was a bit confusing when everything you read everywhere is saying to type in overclock. Yet I coudl nto find a overclock script anywhere just the .ko module for it. I actually have a 1250 script which I opened and it had the same numbers up to the 1.25 cpu speed. What I do not understand is with the first SD10 rom when I flashed the deprimed kernel I had automatically up to 1200 right in the CM setting and the setcpu. But when I upgraded to the RC3 and reflashed deprimed I was stuck at 1K wierd.

Everything is good now. Running 1.25 @ 80vsel ran stress testing for a long time and rock solid and never got too hot.

[metalspring]

Thanks

It was a bit confusing when everything you read everywhere is saying to type in overclock. Yet I coudl nto find a overclock script anywhere just the .ko module for it. I actually have a 1250 script which I opened and it had the same numbers up to the 1.25 cpu speed. What I do not understand is with the first SD10 rom when I flashed the deprimed kernel I had automatically up to 1200 right in the CM setting and the setcpu. But when I upgraded to the RC3 and reflashed deprimed I was stuck at 1K wierd.

Everything is good now. Running 1.25 @ 80vsel ran stress testing for a long time and rock solid and never got too hot.

try benchmark apps like antutu, quadrant standard and cf bench, they stress the cpu much more to test stability, if it freezes or the app randomly quits then raise the vsel to 82, test again, if the same happens then raise it to 84, then 86 is the highest you should go