**Support has moved. See the following link for full instructions on how to update to EC02 with root, CWR**
For support on the Galaxy Tab visit #androidchat in Freenode IRC.
This method is for those that may have goofed recovery or screwed up somewhere else. Credit to Koush and Deodexed for getting me the files. All credit goes to them, as all i did was do the write up
They saved my tab with 5% battery left. LOL
Note that myself and/or DroidForums are not responsible for anything you may do to your device. If you know your battery is running low, read through this and get yourself familiar with the process before turning on your tab. if your battery fails during flash process you may be entirely screwed. you've been warned.
These are stock restore files for Download Mode (Volume down and power)
Launch download mode on your tab that is already connected to your PC.
unzip heimdall and go into the drivers folder where you will see zadig.exe. Run this.
At the top you see options. Click "list all devices"
Then in the dropdown select Android USB composite device (or whatever it says). (NOT mass storage)
Click start and let heimdall download the drivers. Once its finished, close zadig and launch heimdall front end. (leaving Tab plugged in and in download mode obviously)
THIS IS THE IMPORTANT PART!!!!!! DO NOT SCREW THIS UP< I AM NOT RESPONSIBLE!!
Unzip the stock files.
Now its common sense.
the zImage goes in both the Kernel AND Recovery slot. (they even tell you where things go with little descriptions)
The system.rfs goes in Factoryfs
The Param.lfs goes in Param.lfs
and the cache goes in the cache slot.
DO NOT EVER EVER EVER PUT ANYTHING IN ANY OTHER LOCATION. THESE ARE THE ONLY FILES YOU NEED.
After you have the files in place click start to flash. ALWAYS make sure your battery is sufficiently charged or you will have MAJOR problems.
After this runs you will more then likely boot loop. Power down, wait a few seconds and hold power and up volume to boot into recovery. (NOTE, do not hold power too long, just long enough to turn it on, then continue holding up volume till you see recovery. WIPE DATA AND CACHE. Tab should boot.
Note, if heimdall fails at the very beginning, just try unplugging and turning off the tab, close, and relaunch heimdall. it will eventually start. sometimes you just need the right combo of plugging in launching the program... Hope this helps a few!!