Been running 220.127.116.11 Cyanogen fine on 600-1000mhz. Decided to try the new JIT app on the Market, and it caused my phone to reboot loop or hang then reloop (JIT has worked fine before when I entered it manually through build.prop and file install).
Tried to do Nandroid backup restores, a few were successful but then when I got to the home screen it would freeze and reboot. These were done with complete wipes.
Then completely wiped and installed a fresh 18.104.22.168 rom through clockwork recovery. It worked but then would hang when I went to my launcher.
It was at this point when it looped, it would get stuck on the M screen. Sometimes it would get to the Droid eye but then freeze.
Now it will not turn on unless I plug it directly into AC. Note, when it is plugged directly into AC the charging light doesn't turn on, but the screen is stuck on the M logo. I can boot into Clockwork recovery when holding X. Whenever I try to flash anything, I get bad MD5 checksums or it freezes.
I then wiped my SD card and even tried booting with the SD card removed.
When I plug it into a USB port on my computer, the phone will not turn on but the charging light appears to be on.
When the phone hangs, I have to do a battery pull to reboot (if it is even successful at that).
I left it plugged in all day on the AC and apparently it's been on the M logo all day because that's where I left it and that's where it is now after I came home from work (12 hours later).
I'm now letting it "charge" (if it IS doing that) on the phone, through my computer USB. I'll check in an hour to see if it held any charge.
I will attempt to flash a 2.0.1 .sbf (since this was the only .sbf I have flashed before, I will go with what works).
I pretty much outlined all the scenarios I just went through. Does anyone have any more ideas? Thanks DF.