Configuring EVDO parameters on D2G
Today I've connected my droid 2 Global brought from US to the local CDMA network in Ukraine.
But only 1x CDMA is currently working here.
The issue is that I can't connect D2G with the QPST.
1. I've installed Motorola 4.8 Drivers. After this, motorola networking device has appeared. I've written 192.168.16.1/24 address and pings to 192.168.16.2 were ok.
2. I used HW VSP 3.1.2 to create virtual serial port. It was successfully created.
3. QPST sees the serial port created by HWVSP and gets some initial information from the phone. But when I start QPST (2.7 build 323) service programming and trying to connect the phone - it fails with the error:
Online connection failure: unspecified error
1x configuration and PRL upload was done by Axesstel program but it's not allowing configuration EVDO.
Did you ever met the issue with QPST and d2g?
Did you ever configure it with any other program?
If to turn on the phone with camera button pressed it appears in windows device manager as a Flash MDM6600. I can't find a driver for it and not sure that this can help me.