GingerShedBread and SetCPU?

[hondabomdc5]

i actually have a problem with gsb and setcpu..... whenever i try to open set cpu and adjust anything it freezes up and i have to do a battery pull

Stupid question but, have you tried to just uninstall and reinstall?

no i havent..... i will try it

[dwoid]

Sorry to resurrect such an old thread, but there may be some new thoughts here...

There do appear to be some conflicts between SetCPU and CM7 (current Stable, 3.0.4 at least) in that CM7's performance => CPU settings will override SetCPU whenever the CM7 module is executed. If you want SetCPU's settings to prevail, the trick is not to allow or accidently force the CM7 module to reload it's settings and execute them...

That is done by (1) unchecking the CM7 "set on boot" checkbox, (2) checking the SetCPU "set on boot" setting, (3) *not* going into CM7's perfromance => CPU settings even to view them (or running SetCPU manually immediately afterwords if you do) and most importantly (4) making sure to run SetCPU's device selection option so that it knows what slot and voltage combinations are available in the kernel you are running.

Personally I like SetCPU for the variety of profiles that can be setup, but was at first concerned when I saw the CM7 CPU settings taking over. A little of the above management seems to take care of allowing SetCPU to run unhampered.

[hackedos]

I had lots of problems using that app with cm7.. I dropped it, and use CPU master at about 765 or so mhz and it's had no problems!

sent from my Eris cm7