This is a guide to make your back LED not only a little brighter but to the point that it can be seen through moderately translucent cases.
DISCLAIMER:This tutorial is written for a user with average on up mechanical aptitude and an ability to follow directions. I assume no
responsibility for an damage that may occur. (Although it isn't likely.)
What you'll need (Labeled in the following picture):
-3/32" drill bit
-Tweezers (or flat head screwdriver or anything flat, really)
-SIM removal tool (pushpin for those like me who lost OEM tool)
-And of course an HTC DNA
1) Power down the device
2) Remove SIM card
3) Use pry tool to pull back off of your DNA
4) Use tweezers to pry up the bottom half of the back notification LED lense (the one in the left, not the flash lense).
Don't worry if the bottom breaks a little we will be gluing it down later.
Then swing the lense out of the way, utilizing the still attached post as a pivot.