For anyone wanting to know the voltage of the presets you can either open up /data/data/com.jrummy.../dxsetup.sh (I think that's what's it's called) and find the preset you're interested in. Or you can open up terminal and run
Sent from my DROIDX
I know I had the interactive governor on my D1 2.2, but I don't see it on the DX. Is this how it's supposed to be?
in my testing i tried to go down to 200mhz. setcpu is showing my minimum at 300 still and will noly go to my 1300, 500, and 800 slots. anybody else get 200 working ?
ok and my second edit. here are the values im using in advanced settings. with the stage fright options turned on (i dont have a clue what that means, but theyre on) im getting quadrant scores between 2500-2800
no reboots yet. quadrant again over 2500, ran a few flash sites no problem. we'll see in the long run...
dont know about going under 200, but the voltages are as follows.
these are the stock slots/vsel
this can be found in the help section of jrummys app. also, i went into data/data/com.jrummy and found ultra low mean a decrease of 4 vsel, low a decrease of 2, standard no change, high +2
im currently trying to run as ulv as possible and squeeze 1.2 out of it. lots of experimenting, 0 success being 100% stable yet.
Last edited by Shelooga; 10-27-2010 at 01:45 PM.
X passed to Jess
Droid also here but retired after hard miles to the land of experimentation and mutilation