DroidForums.net is the original Verizon Android Forum! Registered Users do not see these ads. Please Register - It's Free!
Results 1 to 9 of 9
Like Tree2Likes
  • 1 Post By xtor
  • 1 Post By Bakerboy448

Thread: Help please XT912 screen glitches after Matts JB utility install

  1. Junior Droid
    jpty01's Avatar
    Member #
    343107
    Join Date
    Apr 2013
    Posts
    9
    Phone
    RAZR XT912
    #1

    Help please XT912 screen glitches after Matts JB utility install

    I used Matts utility to install JB on my XT912 that was running Gingerbread. Everything loaded ok but when the phone is running the screen has vertical lines that glitch on and off the lower half of the screen and a glitch on the right side. My phone is stock no root and I did option one to wipe data. I also installed 64 bit Motorola drivers. Is there anything else I can do? I ran the install several times on two different computers but I have not tried it on my Mac yet.
    Thanks for any help.
  2.  
     
     
     
  3. Premium Member
    xtor's Avatar
    Member #
    241487
    Join Date
    Dec 2011
    Location
    Northern Ca
    Posts
    1,279
    Liked
    130 times
    Phone
    note 2
    Premium Member
    #2
    Quote Originally Posted by jpty01 View Post
    I used Matts utility to install JB on my XT912 that was running Gingerbread. Everything loaded ok but when the phone is running the screen has vertical lines that glitch on and off the lower half of the screen and a glitch on the right side. My phone is stock no root and I did option one to wipe data. I also installed 64 bit Motorola drivers. Is there anything else I can do? I ran the install several times on two different computers but I have not tried it on my Mac yet.
    Thanks for any help.
    Is it glitching or flickering?

    razr on 215 leak
  4. Droid Newbie
    JonnyV2889's Avatar
    Member #
    344211
    Join Date
    Apr 2013
    Posts
    2
    Phone
    XT912
    #3
    Quote Originally Posted by jpty01 View Post
    I used Matts utility to install JB on my XT912 that was running Gingerbread. Everything loaded ok but when the phone is running the screen has vertical lines that glitch on and off the lower half of the screen and a glitch on the right side. My phone is stock no root and I did option one to wipe data. I also installed 64 bit Motorola drivers. Is there anything else I can do? I ran the install several times on two different computers but I have not tried it on my Mac yet.
    Thanks for any help.
    Tried doing this same thing. The screen was super glitchly especially down in the keyboard area. After many attempts to flash via matts 1.8 utility I dealt with it for the last week. The issue I believe is some missing file between GB and JB. I finally sat down today to fix my phone, resulted in flashing back to 2.3.5 fastboot file via RSD lite. From there I OTA updated through to 4.1.2. I since tried flashing 4.2.2 which I didn't realize I had the XT910 rom. This led an encryption issue and I had to reflash JB. This time I used matt's utility and the screen is fine.
  5. Premium Member
    xtor's Avatar
    Member #
    241487
    Join Date
    Dec 2011
    Location
    Northern Ca
    Posts
    1,279
    Liked
    130 times
    Phone
    note 2
    Premium Member
    #4
    Quote Originally Posted by JonnyV2889 View Post

    Tried doing this same thing. The screen was super glitchly especially down in the keyboard area. After many attempts to flash via matts 1.8 utility I dealt with it for the last week. The issue I believe is some missing file between GB and JB. I finally sat down today to fix my phone, resulted in flashing back to 2.3.5 fastboot file via RSD lite. From there I OTA updated through to 4.1.2. I since tried flashing 4.2.2 which I didn't realize I had the XT910 rom. This led an encryption issue and I had to reflash JB. This time I used matt's utility and the screen is fine.
    Good to hear
    jpty01 likes this.
  6. Junior Droid
    jpty01's Avatar
    Member #
    343107
    Join Date
    Apr 2013
    Posts
    9
    Phone
    RAZR XT912
    #5
    I would like to try this for my problem. Can anyone direct me how to flash back to 2.3.5 from JB.
  7. Droid
    Bakerboy448's Avatar
    Member #
    257579
    Join Date
    Apr 2012
    Posts
    47
    Liked
    3 times
    Phone
    DROID RAZR
    #6
    @Johnny so unless I am misunderstanding, you were on Jellybean, then magically fastbooted to Gingerbread, and then OTAed (assuming via the OTA being pushed, not via flashing) to JB ?

    Funny thing, if you flash GB or ICS on a JB kernel, it doesn't work, and won't boot, and you end up softbricked.

    @OP are you using the JB utility? Option 1 (wipe)
    jpty01 likes this.
  8. Droid Newbie
    JonnyV2889's Avatar
    Member #
    344211
    Join Date
    Apr 2013
    Posts
    2
    Phone
    XT912
    #7
    [QUOTE=Bakerboy448;2418950]@Johnny so unless I am misunderstanding, you were on Jellybean, then magically fastbooted to Gingerbread, and then OTAed (assuming via the OTA being pushed, not via flashing) to JB ?

    Funny thing, if you flash GB or ICS on a JB kernel, it doesn't work, and won't boot, and you end up softbricked.

    I was originally on GB and tried to flash directly to a 4.2.2 rom. With no luck matt's JB utility was more readily avail than the GB and ICS on. I tried options 1 and 2 numerous times all resulting in the glitchy screen issue. The screen would be fine if I was scrolling but as soon as I stopped it would show a nice colorful design on the lower third, along with being patchy and slow. I found matt's how to for RSD lite after I ran into a low batt issue partial flash. Altered a usb to make a factory cable. I proceeded to download a 2.3.5 fastboot file put the phone in fastboot and flashed with RSD.

    From what I read JB is more of an upgrade to ICS opposed to the 'stand alone' if you will of ICS? Correct me if I am wrong here? I am not sure if I had a kernel issue(didn't update) as I didn't check, but I did have issues booting and black screen issues. Sometimes it took multiple tries to boot up. Otherwise it would go to the back lit black screen after the moto logo. The black screen also persisted after boot up, as it would turn black mid use or would be black returning from an 'off' screen.

    I got my GB fastboot from:
    Droid-Developers SBF

    I believe rsd install was included w matts utility download.

    Just install rsd lite and make sure you have the most recent moto drivers.
    Then follow matt's rsd how to.

    Edit:
    To answer you on the push, yes on push. I went to about phone, check for updates.
    Last edited by JonnyV2889; 05-01-2013 at 11:34 AM.
  9. Junior Droid
    jpty01's Avatar
    Member #
    343107
    Join Date
    Apr 2013
    Posts
    9
    Phone
    RAZR XT912
    #8
    Was this phone rooted or stock?
    From what I am reading you can't go back. Well in this case you can go back I just fastbooted back to 2.3.5 with RSD lite and all my screen glitches are gone. Have not tried OTA Thanks JonnyV.
    Last edited by jpty01; 05-02-2013 at 10:28 PM. Reason: solved
  10. Junior Droid
    jpty01's Avatar
    Member #
    343107
    Join Date
    Apr 2013
    Posts
    9
    Phone
    RAZR XT912
    #9
    Solved You Can fastboot back and my screen problems are gone!!!!

Links

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Similar Threads

  1. [TOOLS] DROID RAZR Utility XT912 Jellybean -- Windows + Mac + Linux (All In One!)
    By mattlgroff in forum Droid RAZR Hacks
    Replies: 114
    Last Post: 03-11-2014, 02:39 PM
  2. Replies: 2
    Last Post: 05-16-2013, 08:28 PM
  3. where can i find matts utility 1.82
    By ted1 in forum Droid RAZR Support
    Replies: 2
    Last Post: 03-23-2013, 03:49 PM
  4. fastboot restore with matts utility
    By joshxdroid in forum Droid RAZR Hacks
    Replies: 7
    Last Post: 10-29-2012, 03:48 PM
  5. Restoring using Matts Utility question - Please Help
    By jtc303 in forum Droid RAZR Support
    Replies: 2
    Last Post: 08-13-2012, 07:23 PM

Search tags for this page

droid x912 screen flicker

,

matts jb

,

matts jb utility

,
my xt912 comes on but has this greyish screen to where i can
,
razr lines on screen bottom 2013
,
vertical lines on droid razr xt912 screen
,

why does my razr have lines after using razr utilty

,
why does my razr have vertical lines after using razor utili
,

why my driod razor xt912 screen turned black after changing

,

xt912 wont boot fully has a black screen

Click on a term to search our site for related topics.
Find us on Google+