Think of it like this, your hand is °98.6 Fahrenheit and °105 is only °6.4 warmer than our own body temperature. You are making a substantial contribution to the temperature if holding the device, although I consider °125F to be hot as this is where most devices will begin to act up.
This must be done any time you switch back to the ondemand governor, it defaults to (300,000) each time....very annoying but necessary
I'm changing the ondemand governor sampling rate from 300000 (three hundred thousand) to 30000 (thirty thousand) using SetCPU.
The difference is that interactive takes you up to the highest slot right from Jump Street, aka start. Where OD first reads what is needed and then goes to that speed, rather than max out first and then poll.
That is why there is a greater drain, not a lot, on battery with interactive due to more time at max slot.
hope that makes sense