Thanks sst45jeff!I wish I found YOUR guide two days ago. Ever since Verizon pushed ICS to me in the soak, I've been trying to get it to install. It downloaded fine, but hung after a minute or two. I have all the downloads already (after following a couple other guides). I'm finally on 4.0.4 / 6.7.246XT875.Verizon.en.US.
I have three points I'd like to make.
1. After reading days of forum posts, just clear out your SD card. My music and video-rips were already on my computer. Same with the eBooks, podcasts, audiobooks, Pictures, and documents (if they weren't already in my Dropbox, Box.com, Sugarsync, Evernote, etc.). TitaniumBackup was syncing online as well. I took the opportunity to reformat the card. This RSDLite/.264 IFC FXZ method only took eight minutes.
2. For me, RSDLite 5.7 only got to 21/21 and rebooted a second time, before going into ICS's "Preparing device" - no clicking on the green android at all (I thought I did something wrong for a moment.)
3. I believe my problem has been not being 100% stock. Like others, I used 43V3R Root to root my phone; but I also used Advast's Mobile Security, which has a anti-removal feature.
Thank you again.
I keeping getting a corrupted file when downloading the 246 file. I download about half of it, then the download say it is complete. However, I can't open the file. Any ideas why this may be happening? Thanks.
I've setup a FTP server at my house for people having trouble getting the file.. I have a hurricane here on LI, so get it while you can. Limit is set to 5 connections. I've included all the files needed in the ZIP. RSDlite, Motorola drivers, and .246 file and instructions. Please only connect if you need the file.
ON battery backup... shutting down..
Last edited by Joeteck; 10-29-2012 at 11:45 AM.
Quick question. After the .246 update was installed I noticed that my signal strength for 3G is horrible and when I am in 4G areas it is not fully maxed either. Both of these were always rock solid in the locations where they should be. I pulled the SiM card and battery, but still no go. If I remember right updating the PRL is not required with 4G or the Bionic is it even possible to do that still?
I just want to say thanks for all the help and support from everyone on here. I'm on ICS now and running smooth and have root access. The next question is this, where can I get some themes or something to customize it now. Lol.... Thanks again...
Sent from my DROID BIONIC using Tapatalk 2
DROID BIONIC....... ROOTED...... ICS.....
Ok so i tried to go back to .902 from .2233 before i found these instructions... so now my bionic is bricked.
trying to fxz to .246 now gets me the "Failed flashing process 1/21 flash mbm "allow-mbmloader-flashing-mbm.bin"" error
RSD Lite is seeing my phone fine and drivers are installed...
Any advice would be appreciated.
Last edited by deprive101; 10-29-2012 at 09:08 PM.
First off, i want to say thanks for the write up.
I have an issue here. I followed the steps exactly, seems that my phone did flash correctly. phone booted, had an adroid dude holding a box and a blue spinny thing, and a bar under him. It rebooted, the M logo came up, and it started to display the droid logo. right now it has been stuck on a white DROID accross the screen. Is there an issue? Or is it just going to take forever to load for the first time? Its been sitting here for 5 or 10 minutes.
Last edited by sst45jeff; 10-30-2012 at 02:23 PM.