Here is the complete log, not much to it.
08/03/12 12:20:00 --------------------------------------------------------------------------------
08/03/12 12:20:00 New Log Started For Software Download.
Um, it's not even TRYING to flash your phone. I think we need to step back here a bit. Give me a list of all the directories in your SamuriHL_HouseOfBionic folder, and the contents of the rsd_scripts folder. Then detail EXACTLY what options you used in the HouseOfBionic script itself. I assume INSTALL 232, then option 1 to push the update (and you verified the update is on the sdcard-ext), option 2 to put the phone in AP Fastboot (and you verified you were in fact looking at the AP Fastboot screen and if it didn't work you read the directions to manually put the phone in AP Fastboot), and that's when you tried option 3 to flash the phone? I'm sure we can figure out what's going on...just will take a little investigative effort. What version of the installers for the HoB are you using? 2.1 and 1.0 I assume? You have the latest Moto driver installed from the link in the OP? Just trying to go over everything that can cause problems.
Attached screenshots showing folder content.
Downloaded 2.1 and 1.0 yesterday evening.
Installed the following:
Ran HouseOfBionic.bat from a command prompt with admin rights.
Option 1 install 232
Connected phone and set to USB charge Only, verified USB debug mode was checked. USB port is 2.0 and not 3.
SS has been removed.
Option 1 push update to sdcard-ext.
Verified the file Blur_Version.5.9.905.XT875.Verizon.en.US(67232).zi p is located on /sdcard-ext/
Option 2 reboot to loader and it did successfully. Phone screen says
AP fastboot flash mode (S)
Ok to Program
Then Option 3 and that is when I get the error.
Alrighty then. I'm going to have you do something I don't normally do. Open the HouseOfBionic script and select the INSTALL 232 option. Don't do anything else with the HouseOfBionic script at this point...just leave it on the next menu for the moment. Now do this:
o) Manually put your phone in AP Fastboot (power off, hold volume down while powering on)
o) Load SDL.exe in the RSD directory
o) Make sure it sees the phone
o) Load the HouseOfBionic(232).xml file in RSD Lite from the rsd_scripts directory
Now here's where it gets a little tricky. When it's done, RSD Lite is likely to be in an error state and your phone will remain in AP Fastboot. Close RSD Lite and then hit option 4 on the HouseOfBionic menu. This will tell you to shut your phone OFF, hold volume up and down, and then press power. Volume down to get to recovery, volume up to select it. When the android comes up, volume up and down at the same time to bring up the recovery menu. Etc. Follow those steps exactly.