Well where to begin.
Ive had this Moto Droid for about 3 weeks now and its bee a good experience.
Last night I took my Droid and plugged it into to charge.
It was on and locked but when I plugged it in to the mini USB the device I don't know turned on (even though it was already on).
So it power cycled on but when the pattern lock screen came on the screen was whacked (only word best to describe it).
I made the un-lock pattern and the lines went everywhere other then where I was touching the screen.
I turned it off and took the battery out waited 30 seconds and then re-inserted the battery and turned it back on.
This time I a app called WaveSecure came on (I installed it about a week ago to check it out).
I was forced to enter in my pin because I was locked out of the device.
Getting past that I started noticing sluggish behavior, and app's that normally setup upon boot-up were fc'ing all over the place...
Since this event its still a bit sluggish (but no where as bad as last night) and apps are still fc'ing but a a lesser rate.
I tried to scan a product in my local Wal~mart today and it froze up.
Right after, I went to call up the phone app and it took what felt like a hour but only was about a minute.
Anyone else have this or know what I need to do???
Its just not behavioring at a 100% as it did